This is the API V2 documentation. To switch out of beta revert back to our API V1.

Open SidemenuDocs
Docs
Close Sidemenu

Configuring an AudioCodes SBC with Telnyxconfiguring-an-audiocodes-sbc-with-telnyx

What is AudioCodes?what-is-audiocodes-

AudioCodes is an Enterprise Session Border Controller (E-SBC), used to protect SIP-based VoIP networks.

Prerequisitesprerequisites

Assuming you have your SBC already set up with your IP-PBX, with one or more clients configured and running calls between them, the following guide highlights specific configuration for use with your Telnyx trunk. We recommend reviewing the entire AudioCodes SBC guide hereTelnyx Developers for full setup.

Instructionsinstructions

Video Walk-throughvideo-walk-through

Coming soon! This walk-through will demonstrate setting up an IP based connection with AudioCodes SBC. We'll also show you how to assign this connection to a newly purchased DID which will allow you to receive inbound calls. Then we'll walk you through how to assign the connection to an outbound profile such that you can make outbound calls!

Configuring your Telnyx Mission Control Portalconfiguring-your-telnyx-mission-control-portal

Step-by-Step Guidestep-by-step-guide

For step by step instructions on each of the requirements on the Telnyx Mission Control Portal, please follow this guideTelnyx Developers. Once you've configured your Telnyx account, you can now proceed to setup AudioCodes SBC following the guide below.

Configuring your AudioCodes SBC using INIconfiguring-your-audiocodes-sbc-using-ini

Step-by-Step Guidestep-by-step-guide

You are now all set on the Mission Control Portal side and are ready to configure your Telnyx trunk within your AudioCodes SBC system.

Define your IP Group:

[ IPGroup ]
IPGroup_Description:  Telnyx 
IPGroup_SIPGroupName: sip.telnyx.com 
[ \IPGroup ]

Define your SIP Proxy:

[ ProxyIp ] 
FORMAT ProxyIp_Index = ProxyIp_IpAddress, ProxyIp_TransportType, ProxyIp_ProxySetId; 
ProxyIp 1 = "192.76.120.10/32:5060", 0, 1;
ProxyIp 2 = "64.16.250.10/32:5060", 0, 1;  
[ \ProxyIp ]

Define Coders:

[ CodersGroup0 ]
CodersGroup0_Name:        g711ulaw64k 
CodersGroup0_pTime:       20 
CodersGroup0_PayloadType: 0
[ \CodersGroup0 ]

Depending on your requirements, you may need to set more configurations such as IP profiles and Routing.

Additional Resourcesadditional-resources

Review our getting started guideTelnyx Developers to make sure your Telnyx Mission Control Portal account is setup correctly!

Check out AudioCodes SBC full guideTelnyx Developers for detailed instructions


Can't find what you're looking for? Chat to our expertsTelnyx Developers.

Was this page helpful?was-this-page-helpful